Sort by
Featured
Most relevant
Best selling
Alphabetically, A-Z
Alphabetically, Z-A
Price, low to high
Price, high to low
Date, old to new
Date, new to old
$36.99
$47.99
In stock
Overview
The S1/S1 Pro nozzle uses a 0.4mm bimetallic nozzle made of special material. The upper part of the nozzle is made of brass, which has better thermal conductivity, and the lower part is made of hardened steel, which ha...
$69.99
$133.99
In stock
Overview
High-pressure cooling fan: Compared to the S1, this high-performance cooling fan provides efficient heat dissipation with lower noise levels. Enjoy a quieter workspace with noise reduced to only 55 dB.
Large Diame...
$13.99
$15.99
In stock
Overview
The screen adapter cable is the cable responsible for transmitting signals to the display device.
Product Specification
Materials
FPC
Length
150 mm
$15.99
$19.99
In stock
Overview
The function of PTFE Tube is to reduce resistance and guide filament. The tube’s inner diameter is 2.7mm, and its outer diameter is 4mm.
Please note that the PTFE tubes are consumables and are at risk of wear, as they ...
$28.84
$39.99
In stock
Overview
The belt is a close drive belt, it is installed at the X/Y/Z axies of the FLSUN S1/T1 printer. Its main function is to transmit the motion of the motor to the three axis.
Compatibility
FLSUN S1 and T1 Printers
Insta...
Quick add
$17.99
$21.99
In stock
Overview
The heatbead sensor unit is a piezoelectric ceramic with a bracket installed, and is used to detect the condition of the surface pressure on the heatbed. There are 3 sensors installed on the bottom of the heatbed.
Com...
$17.99
$23.99
Sold out
Overview
Melt extrusion printers will generate VOCs while printing because the heating temperature of ABS, PC, PA and other materials is relatively high, resulting in more VOCs. Materials such as PLA with lower melting points p...
$19.96
$23.99
In stock
Overview
The air filter fan (9025 fan) is located on the upper right side of the cavity and is used to filter harmful gases in the cavity.
Product Specification
Voltage / Operation Voltage
36 V
Operation Current
0.2 A
Mat...
$36.99
$43.99
In stock
Overview
The camera is used to determine whether any abnormal problems occur during the printing process and alarm in time. It is installed below the X-axis. The camera has remote monitoring and time-lapse photography functions...
$16.99
$25.99
Sold out
Overview
The control board fan (4010) is located inside the upper case and is used to cool the motherboard and driver board to prevent the board from shutting down due to overheating.
Product Specification
Voltage / Operati...
$69.99
$89.99
In stock
*Only applicable to the S1 3D printer.
Showing 12 of 29 products
Load more items
Tags
RECENTLY VIEWED PRODUCTS